Cinnamon Jewellery

I had another play with my rolling mill last week using some of the texture sheets from Etsy shop Rolling Mill Resource . I used some sterling silver and copper sheet and soon discovered it's best to get organized before you start! I cut the sheet to size and worked out which design was going on which piece of metal. I also tried a feather but more on that later. Most of the sheet I used was 20g/0.8mm with one piece of 18g/1.0mm and one of 22g/0.6mm. I've read that you should do a dead pass of the metal through the rolling mill with the gap the same size as the metal and texturing item. I'm not sure what this is supposed to achieve but I don't bother doing it. Judging the correct size of gap between the rollers is a trial and error thing that you discover by setting the gap then starting to roll the metal through. If there's too much resistance you make the gap bigger until there's just enough resistance to roll the metal through without giving y...

The need to make cute, brightly coloured enamel studs propelled me into the world of combining soldering with enamel a couple of years ago. I knew from reading up on it that it was possible to enamel and solder on the same piece but wasn't too confident I was able to do it back then. It was a slightly embarrassing occurance that made me just get on with - I'd made some enamel studs with glued on stud posts. I'd used 2 part epoxy resin which was a job in itself as it set hard after 5 minutes so I had to keep mixing more up. The finished studs looked ok but that little voice in my head kept asking "are you sure you want to use glue?" I wasn't but didn't think I had any other way to do it so I used glue. I sold my first pair and merrily sent them on their way to Canada. A couple of week later the buyer got in touch to say the stud post had come off one of the earrings and the other was hanging off. I was mortified, apologized profusely and refunded her m...

One of my New Year things was to start using up my rather large collection of cabs, including some cab shaped pearl beads I've had for years. So I made a start with these copper earrings. I rolled the copper through my rolling mill with a textured card to give it a lovely swirly pattern and combined the copper with pale pink pearl beads and a fine silver ball. The balls were a total pig to solder on as they kept wriggling around and refusing to solder on the flat side. I have no idea why they were doing this but after a bit of a battle I did get them soldered down in the end! The second pair I made used part of some really lovely sterling silver bracelet toggle fasteners. I remember buying these on ebay several years ago after ebay sent me a voucher. I can't remember why they sent me a voucher other than I was a seller on there at the time. Anyway I bought the flower toggle fasteners as I used to make strung bracelets at the time but never used them all so when I had ...

Photo : Nigel Howe on Flickr Firstly, Happy New Year to everyone!! I hope 2014 proves to be a good year. Like everyone else, the end of the year makes me think about what I've done over the past year and what I want to do in the new year. It's also a time I makes lists. I make lists all the time as they make me feel organized but the start of a new year is the time for lists. I currently have two lists on the go: a "to buy" list...... and a jewellery "to do in 2014" list.... Click on the photos if you really want to see what I've written! I've made a good start on the "to buy" list and I'm now waiting for lots of nice packages to arrive through the post. One thing I have come to realize over the past year is that I have developed a bit of a thing for stamps. My stamp colection now has it's own box to live in. I started buying them to use for etching copper and have also started using them to decorate my j...